Jump to content
Sign in to follow this  
Pinefang

CH Products Pro throttle issue

Recommended Posts

Since installing Falcon 4.33 the radar cursor is out of control. It moves all over the MFD screen and I have no control of it including the locking of targets. Anyone else out there have the same issue? Any fixes? Help if possible would be greatly appreciated.

Share this post


Link to post
Share on other sites
How do you slew the radar cursor normally? Using DirectX keys or key combinations on the joystick?
In controls - axis mapping - avionics there are two axis for the MFD cursor. Set those to "keyboard" unless you are using a analogue micro-stick.

Share this post


Link to post
Share on other sites
Hi Brain, I have always used the microstick on the throttle to slew the radar cursor and it has always worked just fine until 4.33. I assume that the microstick is Direct X it gives me a button #33 when I depress the micro switch button in the UI. I do go into the Avionics set up and set the X and Y axis for slew, when I do this now the X axis settles half way across the window but when I set the Y axis it either goes all the way across the window or doesn't show at all. I can move it back and forth but it always settles far left or far right never in the middle as the X axis does. I have never set them to keyboard before, I will try that though. In the BMS direct X 1.6 program I assign cursor enable to the microswitch. Hope this answers your questions.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

×